Crossover, Passive
Used inside of full range speaker cabinets to separate highs, mids, and lows and send them to their respective speakers within the each cabinet. These are not as efficient as active crossovers because they require all frequencies to draw from the same source of amplification.
Boundary Mic
A microphone mounted on a flat plate that acts as a reflective surface directing sound into the mic capsule. Used for general pick-up over a large area. See PCC, PZM.
Brooks Cinema Series Delay
Outboard sound equipment that can momentarily stores a signal being sent to part of a P.A. system so that delayed reinforced sound reaches the audience at the same time as live sound from the stage.
Level
Sets output volume of individual PA input channels. Usually positioned as sliders at the bottom of the soundboard.
Brooks KM 77 Chorus
Common type of effect that makes sounds fuller and thicker.
I/O
Short for “Input/Output’ and referring to:
1) An in-line console module that contains controls for the input section, output section and monitor section.
2) A module in electronic gear containing input and output amplifiers for the device.
3) A digital port (connector) able to both receive digital data and output digital data.
Initialize
To prepare a digital storage medium (like a floppy disk) so that it will accept and store digital information bits.
Hall Program
A setting of a digital delay/reverb effects unit that approximates concert halls. Hall programs are characterized by pre-delay of up to 25 ms.
Wednesday, March 17, 2021
Brooks Cinema KP 30 Crossover, Passiv
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
It's the part of the sound system that actually magnifies or "amplifies" the sound. In other words, it makes stuff louder. ...
-
A sampler mis-recognizing a signal sent to it that is at a frequency higher than the Nyquist Frequency. Upon playback, the system will pro...
-
1) A device consisting of two or more conducting plates separated from one another by an insulating material and used for storing an elect...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.