A switch placed on the floor and pressed by a musician to do various functions.
Infinite Baffle
A baffle so large that the sounds coming from one side do not reach the other side.
Brooks Cinema TX 509 Equalizer (Parametric, Graphic)
This is used to filter out and adjust specific frequencies in the PA. This is the part of the PA where you have the most control over the band's overall sound. It is also the number one weapon against feedback.
I/O
Short for "Input/Output' and referring to:
1) An in-line console module that contains controls for the input section, output section and monitor section.
2) A module in electronic gear containing input and output amplifiers for the device.
3) A digital port (connector) able to both receive digital data and output digital data.
Brooks RM 80 Beats Per Minute BPM
The number of steady even pulses in music occurring in one minute and there fore defining the tempo of the song.
Ambient Micing
Placing a microphone in the reverberant field (where the reverberation is louder than the direct sound) so as to do a separate recording of the ambience or to allow the recording engineer to change the mix of direct to reverberant sound in recording.
Hearing Limitation
An inability of the ear to hear important characteristics of sound under certain conditions. Characteristics that can be affected include pitch, level, clarity, presence and direction.
Gate
A dynamic processing device that turns a channel off or down when the signal drops below a certain level.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Compact Disc CD
A small optical disk with digital audio recorded on it. Cycle 1) An alternation of a waveform which begins at a point, passes throug...
-
The extreme range of a signal. Usually measured from the average to the extreme. Frets Vertical metal wires which sit vertically on ...
-
The height of a waveform above or below the zero line. Cycle 1) An alternation of a waveform which begins at a point, passes through...
-
Outboard sound equipment that can momentarily stores a signal being sent to part of a P.A. system so that delayed reinforced sound reaches...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.