A sampler mis-recognizing a signal sent to it that is at a frequency higher than the Nyquist Frequency. Upon playback, the system will provide a signal at an incorrect frequency (called an alias frequency). Aliasing is a kind of distortion.
Full Step
A change in pitch that occurs when moving up or down two piano keys
Brooks TA 60 Information Bits
The bits in the digital signal that make up actual values or commands being communicated as opposed to bits that are used for checking & correcting data or other purposes.
Linear
The condition of obtaining a change at the output of the device which is proportional to the change occurring at the input.
Brooks QS 70 Equipment Rack
A cabinet with rails (or free standing rails) that have holes to accept screws at standard spaces and used to house outboard gear.
Chip
1) A slang term with the same meaning as the term IC (a miniature circuit of many components that is in small, sealed housing with prongs to connect it into equipment).
2) The thread cut away from the master lacquer to make the groove, while disc recording.
Graphic Equalizer
An device with several slides controlling the gain of audio signal present which is within one of several evenly spaced frequency bands (spaced according to octaves).
Bandwidth
1) The range of frequencies over which a tape recorder, amplifier or other audio device is useful. 2) The range of frequencies affected by an equalization setting.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Compact Disc CD
A small optical disk with digital audio recorded on it. Cycle 1) An alternation of a waveform which begins at a point, passes throug...
-
The extreme range of a signal. Usually measured from the average to the extreme. Frets Vertical metal wires which sit vertically on ...
-
The height of a waveform above or below the zero line. Cycle 1) An alternation of a waveform which begins at a point, passes through...
-
Outboard sound equipment that can momentarily stores a signal being sent to part of a P.A. system so that delayed reinforced sound reaches...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.