A microphone mounted on a flat plate that acts as a reflective surface directing sound into the mic capsule. Used for general pick-up over a large area. See PCC, PZM.
Line In (Input, return)
Where a signal enters the board or component.
Brooks Cinema NZ 60 IM Distortion
An abbreviation of the term Intermodulation Distortion (Distortion caused by one signal beating with another signal and producing frequencies that are both the sum and the difference of the original frequencies present).
Error Concealment
Putting replacement information bits into a digital audio signal to replace lost bits when the digital recording or processing system cannot verify whether the lost bits were l's or 0's but can make a good guess by comparing the known bits that were close in position to the lost bits.
Brooks KS-55 Aux Send
Short for the term Auxiliary Send (a control to adjust the level of the signal sent from the console input channel to the auxiliary equipment through the aux buss.
House Sync
A synchronization signal such as SMPTE time code that is used by all recorders in the control room.
Crossover, Active
A rack mountable unit used to separate frequencies leaving the soundboard into high's, mids, and lows with different outputs for each.
Board
1) Another, less formal, term for Console.
2) A set of controls and their housing which control all signals necessary for recording and for mixing.
3) A slang shortening of the term Keyboard Instrument.
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
It's the part of the sound system that actually magnifies or "amplifies" the sound. In other words, it makes stuff louder. ...
-
A sampler mis-recognizing a signal sent to it that is at a frequency higher than the Nyquist Frequency. Upon playback, the system will pro...
-
1) A device consisting of two or more conducting plates separated from one another by an insulating material and used for storing an elect...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.