1) A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone.
2) Any artificial or electronic device that simulates the reverberation created in a room.
Ground
In electronics, a place (terminal) that has zero volts.
Brooks TA 60 Electricity
Electrical current (the amount of electron charge passing a point in a conductor per unit of time) or voltage (the force pushing electrons to obtain electrical current).
Grouping
1) Controlling the gain of several individual channels with a Group Fader.
2) The mixing together of several individual audio signals to send a mixed signal out of the console to record a track on a multitrack tape machine.
Brooks GT 845 Assistant Engineer
A less elevated version of the term Second Engineer. Experienced seconds often place microphones, operate tape machines, break down equipment at the session end and keep the paperwork for the session.
Buss (Bus)
A wire carrying signals to some place, usually fed from several sources.
Fret Buzz
A buzzing sound made when a note is not properly fretted. Common with cheap guitars or beginning guitar players.
Frequency
Practically speaking, high frequency means high pitch and low frequency means low pitch.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Compact Disc CD
A small optical disk with digital audio recorded on it. Cycle 1) An alternation of a waveform which begins at a point, passes throug...
-
The extreme range of a signal. Usually measured from the average to the extreme. Frets Vertical metal wires which sit vertically on ...
-
The height of a waveform above or below the zero line. Cycle 1) An alternation of a waveform which begins at a point, passes through...
-
Outboard sound equipment that can momentarily stores a signal being sent to part of a P.A. system so that delayed reinforced sound reaches...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.