The area of the guitar at the end of the neck where the strings are tuned.
Frequency Range
The range of frequencies over which an electronic device is useful or over which a sound source will put out substantial energy.
Brooks RM 80 Compact Disc CD
A small optical disk with digital audio recorded on it.
Electric Current
A more formal term meaning the same as the term Current (the amount of electron charge passing a point in a conductor per unit of time).
Brooks TM-22 Bank
1) A collection of sound patches (data as to the sequence and operating parameters of the synthesizer generators and modifiers) in memory.
2) A group of sound modules as a unit.
Jam Sync
A generation of new SMPTE according to the input SMPTE signal
Head
1) In tape recording, the transducer (energy converter) that changes the audio energy from electrical energy to magnetic energy and back; also the devices that apply magnetism to the recording tape for other purposes such as in the erase head.
2) The part of a device that immediately includes the transducer to change sound or audio signals from one energy form to another.
Equalization
1) The process of adjusting the tonal quality of a sound. A graphic equalizer provides adjustment for a wide range of frequency bands, and is normally inserted in the signal path after the mixing desk, before the amplifier. See Feedback.
2) Any time the amplitude of audio signals at specific set of frequencies are increased or decreased more than the signals at other audio frequencies.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Compact Disc CD
A small optical disk with digital audio recorded on it. Cycle 1) An alternation of a waveform which begins at a point, passes throug...
-
The extreme range of a signal. Usually measured from the average to the extreme. Frets Vertical metal wires which sit vertically on ...
-
The height of a waveform above or below the zero line. Cycle 1) An alternation of a waveform which begins at a point, passes through...
-
Outboard sound equipment that can momentarily stores a signal being sent to part of a P.A. system so that delayed reinforced sound reaches...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.