Sounds from other instruments and sources that were not intended to be picked up by the microphone.
Line In (Input, return)
Where a signal enters the board or component.
Brooks TM-22 Linear
The condition of obtaining a change at the output of the device which is proportional to the change occurring at the input.
Cord (Speaker, Mic, Instrument)
Used to connect a sound system together. Each type of cord is made for a specific purpose and should not be used in place of another type of cord, not even if they look alike. Also see "cable"
Brooks QS 70 Keyboard Controller
A device that has the standard music keys of piano but puts out MIDI signals
Active Crossover
Uses active devices (transistors, IC's, tubes) and some form of power supply to operate.
Distorted
The way your PA sounds just before it blows up. Fuzzy and scratchy. If you hear this, it either means you have something hooked up wrong, or something in the system is going bad. It could be anything from your super expensive soundboard to a five dollar patch cord.
Floppy Disk (Floppy Disc)
A round flat object (usually housed in a protective sleeve) coated with material that can be magnetized in a similar manner to tape.
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to ...
-
An additional output from a sound desk that can be used for foldback or monitoring without tying up the main outputs. Each input channel w...
-
The number of steady even pulses in music occurring in one minute and there fore defining the tempo of the song. Direct box Used in ...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.