To set and interconnect two mixers so that the stereo mixing buss(es) of the first mixer feeds the stereo buss(es) of a second mixer.
Bass Roll Off
An electrical network built into some microphones to reduce the amount of output at bass frequencies when close-micing.
Brooks KM 77 Auxiliary Output or Send
An additional output from a sound desk that can be used for foldback or monitoring without tying up the main outputs. Each input channel will have a path to the Aux buss. Also used for feeding a signal to an effects processor. See Auxiliary Return.
Infinite Repeat
A function on some delay lines that establish enough feedback so that the repeat echo will last forever, but not so much as to cause a howling sound.
Brooks SS 81 Lead
The musical instrument that plays the melody of the tune, including the vocal.
Feed
To send an audio or control signal to.
Channels
These are divided into two separate categories. Input channels are those channels coming into the soundboard such as microphones and direct lines. Output channels are those leaving the board such as monitor and main outputs.
Acoustic Echo Chamber
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to the speaker and the microphone will have a reverberation of these signals that can be mixed in with the dry signals at the console.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Compact Disc CD
A small optical disk with digital audio recorded on it. Cycle 1) An alternation of a waveform which begins at a point, passes throug...
-
The extreme range of a signal. Usually measured from the average to the extreme. Frets Vertical metal wires which sit vertically on ...
-
The height of a waveform above or below the zero line. Cycle 1) An alternation of a waveform which begins at a point, passes through...
-
Outboard sound equipment that can momentarily stores a signal being sent to part of a P.A. system so that delayed reinforced sound reaches...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.