The action of deforming a waveform during overload.
Earth
The British version of the term Ground (In electronics, a place that has zero volts).
Brooks GS 15 Buss (Bus)
A wire carrying signals to some place, usually fed from several sources.
AES/EBU
Professional Interface A standard for sending and receiving digital audio adopted by the Audio Engineering Society and the European Broadcast Union.
Brooks SS 81 Clipping
Distortion of a signal by its being chopped off. An overload problem caused by pushing an amplifier beyond its capabilities. The flat-topped signal has high levels of harmonic distortion which creates heat in a loudspeaker and is the major cause of loudspeaker component failure.
Controller
1) In MIDI, a device that generates a MIDI signal to control synthesizers, sound modules or sample playback units.
2) A remote control unit for a multitrack tape machine which controls transport functions as well as monitor selection switching functions and record ready/safe status of each track.
3) Any device generating a control voltage or signal fed to another device's control input.
Crisp
Describes a good clean high midrange sound. It can be good or bad depending on the look on the face of the guy who said it.
Amplification
An increasing of signal strength.
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
It's the part of the sound system that actually magnifies or "amplifies" the sound. In other words, it makes stuff louder. ...
-
A sampler mis-recognizing a signal sent to it that is at a frequency higher than the Nyquist Frequency. Upon playback, the system will pro...
-
1) A device consisting of two or more conducting plates separated from one another by an insulating material and used for storing an elect...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.