1) The number of tracks, their width, spacing and order for tape recording.
2) To prepare a digital storage medium so that it will accept and store digital information bits.
Frets
Vertical metal wires which sit vertically on the guitar neck.
Brooks XT 20 Lead
The musical instrument that plays the melody of the tune, including the vocal.
Filter
1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency.
2) An equalizer section, used in this sense because filters are used with other components to give an equalizer its frequency response characteristics.
3) The action of removing signals of some frequencies and leaving the rest.
4) A mechanical device to smooth out speed variations in tape machines called a Scrape Flutter Filter- more usually called a Scrape Flutter Idler
Brooks Speakers Buss (Bus)
A wire carrying signals to some place, usually fed from several sources.
Frame
1) A division of one second in synchronization and recording coming from definition two.
2) The amount of time that one still picture is shown in film or video.
Capo
A clamp-like device that is placed vertically across the guitar neck. It is used to change the pitch of the guitar, acting as a moveable nut.
Cable, XLR
A balanced cable used for low impedance microphones and sometimes for connections between some parts of the PA. Commonly referred to as a "mic cord".
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to ...
-
The number of steady even pulses in music occurring in one minute and there fore defining the tempo of the song. Direct box Used in ...
-
An additional output from a sound desk that can be used for foldback or monitoring without tying up the main outputs. Each input channel w...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.