1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency.
2) An equalizer section, used in this sense because filters are used with other components to give an equalizer its frequency response characteristics.
3) The action of removing signals of some frequencies and leaving the rest.
4) A mechanical device to smooth out speed variations in tape machines called a Scrape Flutter Filter- more usually called a Scrape Flutter Idler
Fidelity
The recording or reproduction quality.
BROOKS AUDIO DESIGN Cable, TRS
A less common balanced cable that has 3 different contacts on its 1/4 inch connectors. Most headphone jacks are a good example of a TRS (Tip-Ring-Sleeve) connector. These are sometimes used instead of the more common XLR connection.
Ampere
The unit of current, abbreviated Amp.
Brooks Cinema QS - 95 Cable, 1/4 inch
An unbalanced cable most often used for instruments and patch cords. Commonly referred to as "guitar cords".
Arc
The visible sparks generated by an electrical discharge.
Expansion
The opposite of compression; for example, an expander may allow the signal to increase 2 dB every time the signal input increased by 1 dB.
Diaphragm
A thin flexible membrane or cone that vibrates in response to electrical signals to produce sound waves. Distortion is usually referred to in terms of total harmonic distortion (THD) which is the percentage of unwanted harmonics of the drive signal present with the wanted signal. Generally used to mean any unwanted change introduced by the device under question.
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to ...
-
The number of steady even pulses in music occurring in one minute and there fore defining the tempo of the song. Direct box Used in ...
-
An additional output from a sound desk that can be used for foldback or monitoring without tying up the main outputs. Each input channel w...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.