To send an audio or control signal to.
Line Input
An input designed to take a line level signal.
Brooks XS - 45 Diffraction
The breaking up of a sound wave caused by some type of mechanical interference such as a cabinet edge, grill frame, or other similar object.
Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.
Brooks VT-50 Electric Current
A more formal term meaning the same as the term Current (the amount of electron charge passing a point in a conductor per unit of time).
Bandwidth
1) The range of frequencies over which a tape recorder, amplifier or other audio device is useful. 2) The range of frequencies affected by an equalization setting.
Dry
Describes a sound coming from the PA with no effects on it.
Line Out (Output, Send)
Where a signal leaves the board or component.
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to ...
-
The number of steady even pulses in music occurring in one minute and there fore defining the tempo of the song. Direct box Used in ...
-
An additional output from a sound desk that can be used for foldback or monitoring without tying up the main outputs. Each input channel w...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.