The portion of the instrument which makes the vibrating source move more air or move air more efficiently; this makes the sound of the instrument louder. Examples of acoustic amplifiers include:
1) The body of an acoustic guitar,
2) The sounding board of a piano,
3) The bell of a horn and
4) The shell of a drum.
Link
(Said of compressors and dynamic processing units.) To combine the control input signals of two channels of a compressor (o
Brooks Audio Design QS 70 Absorption
Short for the term Acoustical Absorption (quality of a surface or substance to take in, not reflect, a sound wave).
Haas Effect
Simply stated, a factor in human hearing where delay has a much bigger effect on human perception of direction than level does.
Brooks VT-50 Ground
In electronics, a place (terminal) that has zero volts.
Cue Send Control
A control that will adjust the amount of signal sent to a cue buss from a console channel.
Isolation Booth/ Isolation Room
A room that prevents loud sounds from other instruments from leaking in: an isolation booth is usually a smaller room that could be used for only one musician.
Boom Stand
A microphone stand equipped with a telescoping support arm to hold the microphone.
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to ...
-
The number of steady even pulses in music occurring in one minute and there fore defining the tempo of the song. Direct box Used in ...
-
An additional output from a sound desk that can be used for foldback or monitoring without tying up the main outputs. Each input channel w...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.