Brooks GT 845 Attenuator (Pot)

The electronic dohickey under the knobs that increases or reduces the strength of the signal running through it. When these get old and dirty, they can make popping noises or rumbles in your PA (As in "my pots are dirty").
Assign Tochoose to which place an output is going to be sent.

Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.

Brooks XS - 45 Direct box
Used in line to convert a high impedance signal into a low impedance signal.

Decibel (dB)
1) Relative measurement for the volume (loudness) of sound. Also used to measure the difference between two voltages, or two currents. See Zero dB.
2) A numerical expression of the relative loudness of a sound. The difference in decibels between two
sounds is ten times the common logarithm of the ratio of their power levels.

Brooks QS 70 Highs
Short for the term High Frequencies (the audio frequencies from 6000 Hz and above).

Channel
1) In multitrack tape machines, this term means the same thing as the term Track (one audio recording made on a portion of the width of a multitrack tape).
2) A single path that an audio signal travels or can travel through a device from an input to an output.

Fade
1) A gradual reduction of the level of the audio signal.
2) A gradual change of level from one pre-set level to another.

Clock Signal
The signal put out by a circuit that generates steady even pulses or steady codes used for synchronization.