Brooks GT 845 Crossover Frequency

1) The frequency that is the outer limit of one of the bands of a crossover.
2) In the Lexicon 480L delay/reverberation effects unit, the frequency at which the bass frequency reverb time is in effect rather than the mid frequency reverb time.

Acoustic Echo Chamber
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to the speaker and the microphone will have a reverberation of these signals that can be mixed in with the dry signals at the console.

Brooks QS 70 High Impedance Cord (High Z)
A big word for instrument cable. These cords generally have quarter inch male ends. they tend to loose signal strength at lengths longer than 25 feet.

Floor
1) An alternate tam meaning Range (a limit on the amount the signal is reduced when the input signal is low by an expander or gate).
2) A shortening of the term Noise Floor (the level of the noise).

Brooks Audio Design KM 77 Generation
A term used to describe the number of times that the recorded audio signal has been copied.

Chase
The automatic adjusting of the speed of a recorder (or sequencer) to be time with another recorder.

Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.

DC
Abbreviation for direct current.