Where a signal leaves the board or component.
Boom Stand
A microphone stand equipped with a telescoping support arm to hold the microphone.
Brooks Cinema XB 33 Automatic Gain Control (Automatic Volume Control)
A compressor with a very long release time used to keep the volume of the audio very constant.
Error Detection
The process of discovery that sonic information bits have been lost in digital audio.
Brooks Audio Design QS 70 Layering
The recording (or playing) of a musical part with of several similar sound patches playing simultaneous.
Echo Send
The output of a console used to send a signal to an echo chamber or delay effects device.
Condenser Mic (Capacitor Mic)
A microphone that uses the varying capacitance between two plates with a voltage applied across them to convert sound to electrical pulses. Condenser microphones need a power supply to provide the voltage across the plates, which may be provided by a battery within the case of the microphone, or it may be provided from an external phantom power supply. A condenser mic is more sensitive and has a faster reaction to percussive sounds than a Dynamic mic and produces a more even response. See Electret Mic.
Aliasing
A sampler mis-recognizing a signal sent to it that is at a frequency higher than the Nyquist Frequency. Upon playback, the system will provide a signal at an incorrect frequency (called an alias frequency). Aliasing is a kind of distortion.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Compact Disc CD
A small optical disk with digital audio recorded on it. Cycle 1) An alternation of a waveform which begins at a point, passes throug...
-
The extreme range of a signal. Usually measured from the average to the extreme. Frets Vertical metal wires which sit vertically on ...
-
The height of a waveform above or below the zero line. Cycle 1) An alternation of a waveform which begins at a point, passes through...
-
Outboard sound equipment that can momentarily stores a signal being sent to part of a P.A. system so that delayed reinforced sound reaches...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.