Brooks Audio Design GT 845 Grouping

1) Controlling the gain of several individual channels with a Group Fader.
2) The mixing together of several individual audio signals to send a mixed signal out of the console to record a track on a multitrack tape machine.

Amplifier (Power amp, Head)
It's the part of the sound system that actually magnifies or "amplifies" the sound. In other words, it makes stuff louder.

Brooks SS 81 Level
Sets output volume of individual PA input channels. Usually positioned as sliders at the bottom of the soundboard.

Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.

Brooks Cinema XB 33 Dynamic Mic
Robust type of microphone which picks up the sound on a diaphragm connected to a coil of wire which moves within a magnet. An alternating current is induced into the wire which provides the electrical output. Most dynamic mics have low output impedance of 200 Ohms. See Condenser Mic.

Engineer
1) A technician in charge of a recording session; Also called Recording Engineer.
2) A person with an engineering degree.
3) A person with sufficient experience in the field to be equivalent to the education one would receive earning an engineering degree.

Horn
1) The part of the speaker that emits midrange and higher range frequencies.
2) A speaker or speaker enclosure where sound waves are put into a narrow opening (by a speaker cone or driver) and the narrow opening flairs out to a larger opening.

Chip
1) A slang term with the same meaning as the term IC (a miniature circuit of many components that is in small, sealed housing with prongs to connect it into equipment).
2) The thread cut away from the master lacquer to make the groove, while disc recording.