Brooks Cinema Projectors Guitar Controller

An electric guitar or device played like an electric guitar that puts out MIDI signals that can be used to control synthesizers and sound modules.

Ambient Field
A term with the same meaning as the term Reverberant Field (the area away from the sound source where the reverberation is louder than the direct sound).

Brooks Audio Design TM-22 Byte
A grouping of eight information bits.

Frequency
Practically speaking, high frequency means high pitch and low frequency means low pitch.

BROOKS AUDIO DESIGN Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other electrons) and attracts opposite (positive) forces.

Feedback
1) The delayed signal sent back to the input of a delay line, used in repeat-echo effects.
2) The pickup of the signal out of a channel by its input or the howling sound that this produces.
3) In an amplifier, the phase reversed output signal sent back to its input, reducing gain but also distortion and noise.
4) This occurs when the sound coming out of the speakers goes back into the microphones, then back out the speakers, then back into the mics…and so on. This can build very quickly to a point where everyone in the room is holding their ears and screaming at you. It can also cause damage to the PA.

Error Message
A prompt on a computer screen telling the operator that an error has occurred.

Bass
1) The lower range of audio frequencies up to approximately 250 Hz.
2) Short for Bass Guitar.
3) Lower end of the musical scale. In acoustics, the range (below about 200 Hz) in which there are difficulties, principally in the reproduction of sound, due to the large wavelengths involved.
4) The lower frequencies.
5) On the soundboard this should refer to the bass guitar channel, not the bass drum.
6) The lowest frequencies of sound. Bi-Amplification uses an electronic crossover or line-level amplifiers for the high and low frequency loudspeaker drivers.