Brooks Cinema XB 33 Feedback Control

The control on a delay line or delay effects device that controls the amount of feedback.

Crisp
Describes a good clean high midrange sound. It can be good or bad depending on the look on the face of the guy who said it.

Brooks KM 22 Balance
1) The relative level of two or more instruments in a mix, or the relative level of audio signals in the channels of a stereo recording. 2) To make the relative levels of audio signals in the channels of a stereo recording even.

Inductor
A device designed primarily to introduce inductance into an electric circuit. Sometimes called a choke or coil.

Brooks Speakers Feedback
1) The delayed signal sent back to the input of a delay line, used in repeat-echo effects.
2) The pickup of the signal out of a channel by its input or the howling sound that this produces.
3) In an amplifier, the phase reversed output signal sent back to its input, reducing gain but also distortion and noise.
4) This occurs when the sound coming out of the speakers goes back into the microphones, then back out the speakers, then back into the mics…and so on. This can build very quickly to a point where everyone in the room is holding their ears and screaming at you. It can also cause damage to the PA.

Comb Filter
1) The frequency response achieved by mixing a direct signal with a delayed signal of equal strength especially at short delays.
2) Loosely used to also describe effects that can be achieved with comb filtering as part of the processing.

Error Concealment
Putting replacement information bits into a digital audio signal to replace lost bits when the digital recording or processing system cannot verify whether the lost bits were l's or 0's but can make a good guess by comparing the known bits that were close in position to the lost bits.

Fat
Having more than a normal amount of signal strength at low frequencies or having more sound than normal (by use of compression or delay).