A set of controls, on one housing, for an in-line console that has two channels (one for recording and one for monitoring) and has controls for all console sections.
Crossover, Active
A rack mountable unit used to separate frequencies leaving the soundboard into high's, mids, and lows with different outputs for each.
Brooks Audio Design Review QS 70 Flamenco
A style of music with roots in Spanish and Arabic culture.
Effects
1) Various ways an audio signal can be modified by adding something to the signal to change the sound.
2) Short for the term Sound Effects (sounds other than dialogue, narration or music like door closings, wind, etc. added to film or video shots).
Brooks Audio Design QS 70 Close Micing
A technique of placing a microphone close to the sound source (within one foot) in order to pick up mainly the direct sound and to avoid picking up leakage or ambience.
Cord (Speaker, Mic, Instrument)
Used to connect a sound system together. Each type of cord is made for a specific purpose and should not be used in place of another type of cord, not even if they look alike. Also see "cable"
Floor
1) An alternate tam meaning Range (a limit on the amount the signal is reduced when the input signal is low by an expander or gate).
2) A shortening of the term Noise Floor (the level of the noise).
Leakage
Sounds from other instruments and sources that were not intended to be picked up by the microphone.
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to ...
-
An additional output from a sound desk that can be used for foldback or monitoring without tying up the main outputs. Each input channel w...
-
The number of steady even pulses in music occurring in one minute and there fore defining the tempo of the song. Direct box Used in ...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.