Any device that allows one unit to work, drive or communicate with another unit when they cannot do so by just feeding each other often because the units are manufactured by different companies.
Gain Control
A device that changes the gain of an amplifier or circuit, often a knob that can be turned or a slide that can be moved up arid down.
BROOKS AUDIO reviews Fader
A control to control the gain of a channel on the console, thereby determining the level of the signal in that channel.
Attenuation
A making smaller: reduction of electrical or acoustic signal strength.
Brooks XM 204 Chorus
Common type of effect that makes sounds fuller and thicker.
ADAT
A trademark of Alesis Corporation designating its modular digital multitrack recording system released in early 1993.
Console
A set of controls and their housing, which control all signals necessary for recording and mixing.
Crossover
1) A route leading from one side of the stage to the other, out of the audiences view.
2) An electronic filter in a sound system that routes sound of the correct frequency to the correct part of the speaker system. Different speakers handle high frequencies (tweeters) and low frequencies (woofers). Sometimes known as a crossover network. An active crossover splits the signal from the mixing desk into high, mid and low frequencies which are then sent to three separate amplifiers.
3) An electrical circuit that divides a full bandwidth signal into the desired frequency bands for the loudspeaker components.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Compact Disc CD
A small optical disk with digital audio recorded on it. Cycle 1) An alternation of a waveform which begins at a point, passes throug...
-
The extreme range of a signal. Usually measured from the average to the extreme. Frets Vertical metal wires which sit vertically on ...
-
The height of a waveform above or below the zero line. Cycle 1) An alternation of a waveform which begins at a point, passes through...
-
Outboard sound equipment that can momentarily stores a signal being sent to part of a P.A. system so that delayed reinforced sound reaches...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.