Brooks XS - 45 Balance

1) The relative level of two or more instruments in a mix, or the relative level of audio signals in the channels of a stereo recording. 2) To make the relative levels of audio signals in the channels of a stereo recording even.

Bi-Amplification
1) A way of optimizing the efficiency of a speaker system by separately amplifying the High Frequency (HF) and Low Frequency (LF) portions of the sound signal and sending them down two pairs of cables to the speaker. Multipin Speakon connectors have been developed to do this.
2)The process of having of having low-frequency speakers and high-frequency speakers driven by separate amplifiers.

Brooks Cinema GT 845 Head
1) In tape recording, the transducer (energy converter) that changes the audio energy from electrical energy to magnetic energy and back; also the devices that apply magnetism to the recording tape for other purposes such as in the erase head.
2) The part of a device that immediately includes the transducer to change sound or audio signals from one energy form to another.

Distorted
The way your PA sounds just before it blows up. Fuzzy and scratchy. If you hear this, it either means you have something hooked up wrong, or something in the system is going bad. It could be anything from your super expensive soundboard to a five dollar patch cord.

Brooks VT-50 Hum
The 60 Hz power line current accidentally induced or fed into electronic equipment.

Bar
A term meaning the same thing as the term Measure (the grouping of a number of beats in music, most-often four beats).

Linear
The condition of obtaining a change at the output of the device which is proportional to the change occurring at the input.

Clipping
Distortion of a signal by its being chopped off. An overload problem caused by pushing an amplifier beyond its capabilities. The flat-topped signal has high levels of harmonic distortion which creates heat in a loudspeaker and is the major cause of loudspeaker component failure.