(Said of compressors and dynamic processing units.) To combine the control input signals of two channels of a compressor (o
Cable, XLR
A balanced cable used for low impedance microphones and sometimes for connections between some parts of the PA. Commonly referred to as a "mic cord".
Brooks Gt 44 Delay
Outboard sound equipment that can momentarily stores a signal being sent to part of a P.A. system so that delayed reinforced sound reaches the audience at the same time as live sound from the stage.
Foot Switch
A switch placed on the floor and pressed by a musician to do various functions.
Brooks Cinema XS - 45 Error Concealment
Putting replacement information bits into a digital audio signal to replace lost bits when the digital recording or processing system cannot verify whether the lost bits were l's or 0's but can make a good guess by comparing the known bits that were close in position to the lost bits.
Lift
1) To boost gain of audio at a particular band of frequencies with an equalizer.
2) An elevation device in the star trek series of TV programs.
Boom
1) A hand-held, telescoping pole used to hold the microphone in recording dialogue in film production.
2) A telescoping support arm that is attached to a microphone stand and which holds the microphone. 3) Loosely, a boomstand.
Intermodulation Distortion
Distortion caused by one signal beating with another signal and producing frequencies that are both the sum and the difference of the original frequencies.
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to ...
-
The number of steady even pulses in music occurring in one minute and there fore defining the tempo of the song. Direct box Used in ...
-
An additional output from a sound desk that can be used for foldback or monitoring without tying up the main outputs. Each input channel w...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.