Used to connect a sound system together. Each type of cord is made for a specific purpose and should not be used in place of another type of cord, not even if they look alike. Also see "cable"
Equalizer (Parametric, Graphic)
This is used to filter out and adjust specific frequencies in the PA. This is the part of the PA where you have the most control over the band's overall sound. It is also the number one weapon against feedback.
Brooks XM 204 Electret Mic
A condenser microphone where the capacitor plates are given a charge during manufacture which they retain, therefore requiring no external power supply.
Gate
A dynamic processing device that turns a channel off or down when the signal drops below a certain level.
Brooks Cinema Projectors Error Correct
Exact replacement of lost information bits in digital audio.
Foot Pedal
1) An effects device where the amount of the effect can be controlled by a musician with his foot.
2) The beater mechanism of a foot drum that is activated by the drummer's foot to play the drum.
3) Any device, like a volume control, that can be operated by the foot.
Active Crossover
Uses active devices (transistors, IC's, tubes) and some form of power supply to operate.
Dynamic Mic
Robust type of microphone which picks up the sound on a diaphragm connected to a coil of wire which moves within a magnet. An alternating current is induced into the wire which provides the electrical output. Most dynamic mics have low output impedance of 200 Ohms. See Condenser Mic.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.