The working of a limiter or compressor reducing gain during high-level passages.
Fidelity
The recording or reproduction quality.
Brooks Cinema XB 33 Buss (Bus)
A wire carrying signals to some place, usually fed from several sources.
Assistant Engineer
A less elevated version of the term Second Engineer. Experienced seconds often place microphones, operate tape machines, break down equipment at the session end and keep the paperwork for the session.
Brooks KM 22 Line Level
1) An amplified signal level put out by an amplifier and used as the normal level that runs through the interconnecting cables in a control room.
2) A low level signal such as the signal in a guitar cord. Most parts of a PA require a line level signal. Remember, however, that speaker outputs are not line level. Plugging speaker outs into line ins will result in damage to the equipment
LED
A light that allows current to flow in one direction only and emits light whenever a voltage of a certain level or beyond is applied to it.
Crisp
Describes a good clean high midrange sound. It can be good or bad depending on the look on the face of the guy who said it.
Ground
In electronics, a place (terminal) that has zero volts.
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to ...
-
The number of steady even pulses in music occurring in one minute and there fore defining the tempo of the song. Direct box Used in ...
-
An additional output from a sound desk that can be used for foldback or monitoring without tying up the main outputs. Each input channel w...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.