A collection of digital data stored in a computer's memory bank or on a floppy disc.
Cord (Speaker, Mic, Instrument)
Used to connect a sound system together. Each type of cord is made for a specific purpose and should not be used in place of another type of cord, not even if they look alike. Also see "cable"
Brooks Cinema XB 33 Equalization
1) The process of adjusting the tonal quality of a sound. A graphic equalizer provides adjustment for a wide range of frequency bands, and is normally inserted in the signal path after the mixing desk, before the amplifier. See Feedback.
2) Any time the amplitude of audio signals at specific set of frequencies are increased or decreased more than the signals at other audio frequencies.
Balance
1) The relative level of two or more instruments in a mix, or the relative level of audio signals in the channels of a stereo recording. 2) To make the relative levels of audio signals in the channels of a stereo recording even.
BROOKS AUDIO reviews Electricity
Electrical current (the amount of electron charge passing a point in a conductor per unit of time) or voltage (the force pushing electrons to obtain electrical current).
Auxiliary Input or Return
A route back into the sound desk for a signal sent to a piece of outboard equipment via an auxiliary send.
Contact Microphone
A device that senses vibrations and puts out an audio signal proportional to the vibrations.
Face
The front or body of the guitar.
Subscribe to:
Post Comments (Atom)
Brooks HI FI projectors Compact Disc CD
A small optical disk with digital audio recorded on it. Cycle 1) An alternation of a waveform which begins at a point, passes throug...
-
The extreme range of a signal. Usually measured from the average to the extreme. Frets Vertical metal wires which sit vertically on ...
-
The height of a waveform above or below the zero line. Cycle 1) An alternation of a waveform which begins at a point, passes through...
-
Outboard sound equipment that can momentarily stores a signal being sent to part of a P.A. system so that delayed reinforced sound reaches...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.