Brooks Cinema XB 33 Attenuator (Pot)

The electronic dohickey under the knobs that increases or reduces the strength of the signal running through it. When these get old and dirty, they can make popping noises or rumbles in your PA (As in "my pots are dirty").
Assign Tochoose to which place an output is going to be sent.

Critical Distance
The point a distance away from the sound source where the direct sound and the reverberant sound are equal in volume.

Brooks QS-70 Filter
1) A device that removes signals with frequencies above or below a certain point called the cut-off frequency.
2) An equalizer section, used in this sense because filters are used with other components to give an equalizer its frequency response characteristics.
3) The action of removing signals of some frequencies and leaving the rest.
4) A mechanical device to smooth out speed variations in tape machines called a Scrape Flutter Filter- more usually called a Scrape Flutter Idler

Input
1) The jack or physical location of where a device receives a signal.
2) The signal being received by a device.
3) The action of receiving a signal by a device.

Brooks Cinema GT 845 Current
The amount of electron charge passing a point in a conductor per unit of time.

Ground Adapter Plug
Adapts a three pronged electrical plug to a two pronged wall outlet. This bypasses the ground and may create a hum in the system. A lack of a good ground can cause mild electrical shock when touching a microphone.

Bi-Amplification
1) A way of optimizing the efficiency of a speaker system by separately amplifying the High Frequency (HF) and Low Frequency (LF) portions of the sound signal and sending them down two pairs of cables to the speaker. Multipin Speakon connectors have been developed to do this.
2)The process of having of having low-frequency speakers and high-frequency speakers driven by separate amplifiers.

Blending
1) A condition where two signals mix together to form one sound or to give the sound of one sound source or one performance.
2) Mixing the left and right signal together slightly which makes the instruments sound closer to the center of the performance stage. 3) A method of panning during mixing where instruments are not panned extremely left or right.