A sampler mis-recognizing a signal sent to it that is at a frequency higher than the Nyquist Frequency. Upon playback, the system will provide a signal at an incorrect frequency (called an alias frequency). Aliasing is a kind of distortion.
Capacitance
That property of a capacitor which determines how much charge can be stored in it for a given potential difference between its terminals, measured in farads, by the ratio of the charge stored to the potential difference.
Brooks Cinema KM 22 Boom
1) A hand-held, telescoping pole used to hold the microphone in recording dialogue in film production.
2) A telescoping support arm that is attached to a microphone stand and which holds the microphone. 3) Loosely, a boomstand.
Bridge
The bridge assembly, or just "bridge" is an area on the face of the guitar where the string meet or are connected to the face.
Brooks Cinema Projectors Line Out (Output, Send)
Where a signal leaves the board or component.
Foldback
A European term for the signal sent to the stage monitors in a live performance.
Cord (Speaker, Mic, Instrument)
Used to connect a sound system together. Each type of cord is made for a specific purpose and should not be used in place of another type of cord, not even if they look alike. Also see "cable"
Infinite Baffle
A baffle so large that the sounds coming from one side do not reach the other side.
Subscribe to:
Post Comments (Atom)
Brooks Hi Fi speakers Charge
The electrical energy of electrons. The energy is in the form of a force that is considered negative and repels other like forces (other e...
-
A room designed with very hard, non-parallel surfaces and equipped with a speaker and microphone; dry signals from the console are fed to ...
-
The number of steady even pulses in music occurring in one minute and there fore defining the tempo of the song. Direct box Used in ...
-
An additional output from a sound desk that can be used for foldback or monitoring without tying up the main outputs. Each input channel w...
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.